User avatar
Josh R
Global Moderator
Global Moderator
Posts: 481
Joined: Mon Jun 17, 2013 8:24 pm
Real Name: Josh Reed
YouTube Username: SWOhioSirens
Location: Wilmington, Ohio

Re: Saving a 2T22

Wed Nov 10, 2021 5:41 pm

SDsirenman wrote:
Wed Nov 10, 2021 11:09 am
Oh thank you I got it working now, Thank you very Much MAJOR THUMBS UP
::Edit:: I tested the timer and Test & Cancel do not work, When I press Alert it seems that the attack cam is activated and the attack signal works fine. Other then that its a nice timer
Does it run its cycle or does it cancel immediately after you release the alert or attack buttons? It’s missing the jumper between the last two terminals on the upper terminal block. When the AR timer is paired with a radio, the radio is connected to those terminals so it can be canceled through radio. If you don’t have a radio hooked to it, then you need to have a wire connect between the last two terminals (15 and 16) on the upper block so it doesn’t auto cancel after releasing a signal button.
Josh Reed
Moderator of The Siren Board
23, Ohio


Owner of a Federal Thunderbolt 1000BT, an AR Timer, and a gray 12 volt siren.


My YouTube Channel

SDsirenman
Registered User
Registered User
Posts: 162
Joined: Mon Sep 14, 2020 7:07 am
YouTube Username: NorthCentralSirens
Location: South Dakota
Contact: YouTube

Re: Saving a 2T22

Thu Nov 11, 2021 2:45 am

Well I have to hold in Alert til I hear a click then I can let it go, same with the attack button I have to hold it in until I hear a click The timer runs its cycles like its supposed to 3 minutes of Alert or Attack, I'll make a video of it soon

Return to “Main Outdoor Warning Sirens Board”

Who is online

Users browsing this forum: Bing [Bot], Semrush [Bot] and 56 guests