Discussion of Outdoor Warning Systems
https://www.airraidsirens.net/forums/
What would the estimated cost be? I would expect it to be over $1000...Unit of Civil Defense wrote: ↑Tue Aug 23, 2022 12:56 amDo you have any idea on how it could be re-centered?
Yes, probably will cost you more than what you are willing to pay(machine shop) as carolinasignalco alluded to.....
i just happen to be a aprenticing machinist. i might give you a discount. maybe, maybe not. no promisesUnit of Civil Defense wrote: ↑Tue Aug 23, 2022 12:56 amDo you have any idea on how it could be re-centered?StormanCharlie wrote: ↑Fri Aug 19, 2022 3:16 pmDo you have any idea on how it could be re-centered? Or should I just go with Chicagosiren-hunters's advice?Unit of Civil Defense wrote: ↑Fri Aug 19, 2022 1:25 am.....Also note how the spindle (small round piece) inside the hub (Piece that the set screws are screwed into) is not centered,...that is what is causing the contact w/ the chopper.....the spindle is more than likely correctly centered and the hub , for what ever reason, is not centered correctly.
Yes, probably will cost you more than what you are willing to pay(machine shop) as carolinasignalco alluded to.....
Or should I just go with Chicagosiren-hunters's advice?
No, grinding on the stator wont solve this issue.
Alright. Thank you again for the help!Unit of Civil Defense wrote: ↑Tue Aug 23, 2022 11:20 pm....I have no idea, it's been a while (like the last millennium) since I have had any machine shop work done. Since it's small enough, I suppose you could take around to some shops and see what they have to say.