Posted: Fri Nov 03, 2006 8:59 pm
all tho it was kind dumb to stick his hand into the siren to slow it down 
The Siren Board
Discussion of Outdoor Warning Systems
https://www.airraidsirens.net/forums/
Two Carter sirens being spun with a drill.
Page 2 of 3
Posted: Fri Nov 03, 2006 10:11 pm
I guess that putting them against the rotor vanes at that time didn't hurt.
Posted: Sat Nov 04, 2006 2:48 am
Nelso90 wrote:That must be one hell of a drill!
I do believe that is one of those corded 1/2 HP drills that have like a 1/2 inch chuck
Posted: Sat Nov 04, 2006 6:55 pm
How big is the motor on a Carter siren?
Posted: Sat Nov 04, 2006 9:03 pm
I could get my 2t22 going with my Makita sidewinder.That must be one hell of a drill!
Posted: Sat Nov 04, 2006 10:06 pm
I could growl my Model 2 with the battery from an 18 volt drill. A couple of them in series could get up to several hundred RPM.
Posted: Sat Nov 04, 2006 10:16 pm
The motors on those Carters seem to average about ten or so inches. I am not sure about many others.
Posted: Sun Nov 05, 2006 2:15 am
No...I mean horsepower.
Posted: Sun Nov 05, 2006 7:32 pm
Does this look weird or is it me. One rotor spinning one way and the other oposite. Or is it due to the camera? Strange! I'd love to have those to play with!http://www.youtube.com/watch?v=2cQT8Trj ... ed&search=
Posted: Sun Nov 05, 2006 8:38 pm
its the camera