Page 4 of 4

Re: My Federal Signal 2001:DC (Squareback) *New pics page 2*

Posted: Sat Nov 16, 2013 4:55 pm
by Tyler
If I'm not mistaking the rotor in the 2001s are smaller then the sth-10s right?

Re: My Federal Signal 2001:DC (Squareback) *New pics page 2*

Posted: Sat Nov 16, 2013 6:20 pm
by Mark N
Thunderbolt10031 wrote:If I'm not mistaking the rotor in the 2001s are smaller then the sth-10s right?
Yes, the STH-10s have a 22 inch diameter, as the STL-10s had a 24 inch diameter, if I am not mistaken.

Re: My Federal Signal 2001:DC (Squareback) *New pics page 2*

Posted: Sat Nov 16, 2013 6:22 pm
by sirendude2012
Mark N wrote:
Thunderbolt10031 wrote:If I'm not mistaking the rotor in the 2001s are smaller then the sth-10s right?
Yes, the STH-10s have a 22 inch diameter, as the STL-10s had a 24 inch diameter, if I am not mistaken.
He was comparing the 2001 and the STH, not the STH with the STL. lol

The 2001 has a rotor diameter that is a little bit more than half the diameter of an STH rotor. The STH has a 22 inch rotor while the 2001 has a 12 inch.

Re: My Federal Signal 2001:DC (Squareback) *New pics page 2*

Posted: Sat Nov 16, 2013 6:31 pm
by Mark N
sirendude2012 wrote:
Mark N wrote:
Thunderbolt10031 wrote:If I'm not mistaking the rotor in the 2001s are smaller then the sth-10s right?
Yes, the STH-10s have a 22 inch diameter, as the STL-10s had a 24 inch diameter, if I am not mistaken.
He was comparing the 2001 and the STH, not the STH with the STL. lol

The 2001 has a rotor diameter that is a little bit more than half the diameter of an STH rotor. The STH has a 22 inch rotor while the 2001 has a 12 inch.
I knew that he was comparing a 2001 to an STH, I just threw in the STL in there. But yeah, the 2001 rotor is half the size of the STH rotor

Re: My Federal Signal 2001:DC (Squareback) *New pics page 2*

Posted: Sun Nov 17, 2013 3:02 am
by holler
2001 rotor is 14, not 12 inches in diameter

Re: My Federal Signal 2001:DC (Squareback) *New pics page 2*

Posted: Mon Nov 18, 2013 1:31 am
by Rick K
I feel like I need to reiterate what I said at the end of page two...

Rick K wrote:

Eric, it's a 14" rotor.