The Siren Board

I don't own a Thunderbolt, I wish I did, but I don't, but I was wondering if someone could post a photo of what to wire together to make the solenoids pulse, that would be really nice.

EDIT: I was looking at a wiring diagram for the RCM3, and AF, but I can't figure it out.

gman 1 wrote:I don't own a Thunderbolt, I wish I did, but I don't, but I was wondering if someone could post a photo of what to wire together to make the solenoids pulse, that would be really nice.

You would wire both of the solenoids together. It's that simple.

I knew that, but what components do I wire together?

gman 1 wrote:I knew that, but what components do I wire together?

The two solenoids....

Probably the wires in the RC6 box.

Chem_Boffin_6589 wrote:Probably the wires in the RC6 box.

I will probably regret this question, but what part of the siren is that, I have never heard of that.

gman 1 wrote:

Chem_Boffin_6589 wrote:Probably the wires in the RC6 box.

I will probably regret this question, but what part of the siren is that, I have never heard of that.

The RC6 is the part where the solenoids are controlled from; where you can speed up the hi\lo signal and service them.

I am very sorry to ask this, but I don't know what it looks like.

It's in the same box as all the other controls on the siren.

What to parts do I wire together, and where are they?