Page 1 of 1
Model 2 housing dimensions
Posted: Sat Dec 09, 2017 7:35 pm
by Snowcube
I am working on a 3D-printable working 1/6 scale Model 2 siren. I need the dimensions for some parts of the housing (they aren't shown on the FS website). Does anyone here have a Model 2 housing they could measure and get the dimensions shown in the picture below?
Re: Model 2 housing dimensions
Posted: Sat Dec 09, 2017 11:14 pm
by KGK1234
I could see about measuring mine tomorrow.
Re: Model 2 housing dimensions
Posted: Wed Dec 20, 2017 11:05 pm
by Austen_lyon123
Where's The Siren In Your Profile? And Is That A 2T Or A Standard 2?
Re: Model 2 housing dimensions
Posted: Sat Dec 23, 2017 6:19 am
by Snowcube
Austen_lyon123 wrote: ↑Wed Dec 20, 2017 11:05 pm
Where's The Siren In Your Profile? And Is That A 2T Or A Standard 2?
The siren in my profile pic is a ground mounted Allertor in Tipton, KS. Also, I plan on having this available in single and dual tone variations.
Re: Model 2 housing dimensions
Posted: Sat Dec 23, 2017 5:20 pm
by Brendan W
I'll get you some measurements of my 2 shroud a little later if you still need them.