Page 11 of 16
Re: Mini/3d Printed sirens
Posted: Tue Apr 12, 2022 12:07 pm
by carolinasignalco
FSThunderboltfan1000 wrote: ↑Tue Apr 12, 2022 1:53 am
A few things I noticed on your drawing of the T-135.
The rotator gear reducer connects to the main stationary gear on the right side of the main gear, not the rear. The projector horns also do not come from the sides like on the T-128 they bolt to the front like the RM-130 / PN-20. The stator casting directs the ports to the front in the same fashion as the RM-130.
ooof. sorry to inform you, but these prolly wont be fixed. the rotator motor wont even clear at the side.
Re: Mini/3d Printed sirens
Posted: Fri Apr 15, 2022 11:37 am
by carolinasignalco
ready to start printing
Re: Mini/3d Printed sirens
Posted: Sun Apr 17, 2022 7:07 pm
by carolinasignalco
progress is being made
Re: Mini/3d Printed sirens
Posted: Sat Apr 23, 2022 1:26 pm
by carolinasignalco
Re: Mini/3d Printed sirens
Posted: Sat Apr 30, 2022 12:48 am
by carolinasignalco
t135 is near completion
Re: Mini/3d Printed sirens
Posted: Sat Apr 30, 2022 2:25 am
by Central Texas Sirens
That T-135 look's awesome i'm so ready to see it when it's complete!
Re: Mini/3d Printed sirens
Posted: Sat Apr 30, 2022 10:15 pm
by carolinasignalco
Re: Mini/3d Printed sirens
Posted: Sat Apr 30, 2022 10:17 pm
by carolinasignalco
rotator and base done
Re: Mini/3d Printed sirens
Posted: Sat May 28, 2022 4:10 pm
by carolinasignalco
t135 nearly done, im off school, now and i can finnaly finish it. i nedd collector rings, and to fix the back
Re: Mini/3d Printed sirens
Posted: Tue May 31, 2022 1:57 pm
by carolinasignalco
