The Siren Board

This is something I dreamed up a while a go, and the printer is idle (for now) so lets get building! Some might wander wy i have a lean to design aca products, and the reason why is because everyone else makes thunderbolts or model 5s which is why I build hurricanes and banshees. the whole siren is gonna be 70 mm in diameter and use a stick as the utility pole

After seeing your last 2 projects I can't wait to see this finished!

here we are printing the lid

then I grabbed a stick off the woodpile and belt sanded all the bark off
here is the finished product.
than I wrapped a big booger of electrical tape on the stick and ground it so the stick was more or less level.
next Ive glued up the stator to motor mount
next I soldered the wires to the motor and ran them through the pipe on the stator
than I filled the base with hot glue and made sure the stick was level

Done

Spectacular job! I certainly can't wait to see more of your sirens!

What is the length and width of the siren? Btw i love the design!