User avatar
ver tum
Registered User
Registered User
Posts: 2702
Joined: Tue Jan 22, 2008 10:54 pm
YouTube Username: LouisvilleTorn8o
Location: Louisville, Kentucky

Cornell University 2900 series Whelen voice and Whoop

Sat May 31, 2008 9:12 am

This is in Ithaca, NY.
http://youtube.com/watch?v=RPLTQnvSkcY

The Whoop signal sounds different than I'm used to hearing.
Josh
Owner of a Federal Signal Model D
Audio
YouTube

User avatar
md5
Registered User
Registered User
Posts: 1112
Joined: Mon Sep 10, 2007 10:39 am
Real Name: Brett
YouTube Username: bctrainers
Location: Olathe, KS
Contact: Website

Sat May 31, 2008 9:40 am

Listen to that echo however, quite the re-verb from the area around if I am not mistaken! I'm use to hearing it from a rotating Whelen, not an Omni-Directional however. So it's probably why you had those original thoughts. :)
--bc

User avatar
ver tum
Registered User
Registered User
Posts: 2702
Joined: Tue Jan 22, 2008 10:54 pm
YouTube Username: LouisvilleTorn8o
Location: Louisville, Kentucky

Sat May 31, 2008 10:29 am

The Whoop tone is lower pitched than I'm used to hearing on a Whelen. This is perhaps an older 2900 series siren.
Josh
Owner of a Federal Signal Model D
Audio
YouTube

User avatar
SirenMadness
Registered User
Registered User
Posts: 3757
Joined: Mon May 15, 2006 2:47 pm
Location: Windsor, Ontario
Contact: Website

Sat May 31, 2008 4:08 pm

The whoop doesn't go up that far in pitch most likely to reduce wear on the speaker-coils, as going from a really low frequency to a very high one can cause wear sooner, due to changes in temperature.
~ Peter Radanovic

User avatar
JasonC
Administrator
Administrator
Posts: 3447
Joined: Mon May 15, 2006 5:49 pm
YouTube Username: Jsncrso
Location: OBX, NC

Sat May 31, 2008 6:36 pm

SirenMadness wrote:The whoop doesn't go up that far in pitch most likely to reduce wear on the speaker-coils, as going from a really low frequency to a very high one can cause wear sooner, due to changes in temperature.
How would going to a high pitch cause an increase in temperature??? Speaker drivers are designed for higher pitches, low pitches are what causes excessive overheating.

User avatar
ver tum
Registered User
Registered User
Posts: 2702
Joined: Tue Jan 22, 2008 10:54 pm
YouTube Username: LouisvilleTorn8o
Location: Louisville, Kentucky

Sat May 31, 2008 6:43 pm

Jason is right. It takes more energy to produce a lower tone than it does to produce a higher tone. Therefore, the speaker drivers heat up more when producing lower tones
Josh
Owner of a Federal Signal Model D
Audio
YouTube

User avatar
SirenMadness
Registered User
Registered User
Posts: 3757
Joined: Mon May 15, 2006 2:47 pm
Location: Windsor, Ontario
Contact: Website

Sat May 31, 2008 9:35 pm

JasonC wrote:
SirenMadness wrote:The whoop doesn't go up that far in pitch most likely to reduce wear on the speaker-coils, as going from a really low frequency to a very high one can cause wear sooner, due to changes in temperature.
How would going to a high pitch cause an increase in temperature??? Speaker drivers are designed for higher pitches, low pitches are what causes excessive overheating.
What I meant to say was a change in temperature, not higher heat. The higher pitch produces a lesser heat, and the temperature change between the low pitch and the high pitch might be what causes slightly faster wear. So going from warm to slightly cooler might cause faster wear, not the temperature itself, so to keep the temperature more uniform, the pitch would have to be more uniform. Other than that, though, it might just be a newer tone choice.
~ Peter Radanovic

Return to “Videos and Media”

Who is online

Users browsing this forum: Ahrefs [Bot] and 17 guests