The Siren Board

Last time I priced them they where way high........

Do your steel poles have a seperate inner raceway for the wiring or do you just use the pole as the raceway (like a streetlight).

Right, Just the pole itself... It's under 90 volts, If we run over that like 110v for street light, you would need the separation.

What size if the pipe coming from blower on yours? Can you have two or more 90's in yours? Might make for interesting pole for yours.. "hide it all inside"

Pipe is 3" rigid conduit. Actually the former dallas tbolts were installed in that matter. Made for a very clean and neat install. The pole became the blower pipe.

It has cut all my "copper" thief to zero..

EWS Rules wrote:It has cut all my "copper" thief to zero..

Mehh, let 'em fry.

SirenMadness wrote:

EWS Rules wrote:It has cut all my "copper" thief to zero..

Mehh, let 'em fry.

It's stocking more haven't pulling down distribution lines.

My arms got burned, some bad work in disconnect feed was right off transformers,

I should have went after that guy, trying to kill me... "One of my nine lives"

holler wrote:Pipe is 3" rigid conduit. Actually the former dallas tbolts were installed in that matter. Made for a very clean and neat install. The pole became the blower pipe.

Photo's?

EWS Rules wrote:

holler wrote:Pipe is 3" rigid conduit. Actually the former dallas tbolts were installed in that matter. Made for a very clean and neat install. The pole became the blower pipe.

Photo's?

Dallas, Ennis, and Cedar Hill, TX all had the same pole setups on their Thunderbolts.

Cedar Hill:




Ennis:


Dallas:

Very cool.. Are they in operation? In the last photo is "green box" back power for it.. or Radio stuff for tower?